14 Cover
The cover and back plate are manufactured in clear anodized aluminium. The end plates are made
of silver or black painted steel sheet.
14.1 Fitting and removing the cover
The cover is slid over flanges in the back plate so that the ridges fit in the grooves. Snap on the fill
cover into the slot for output shaft. Secure cover with screws.
When properly installed and adjusted, attach the product label, which includes the CE mark on the
right side of the lower part of the operator cover (see illustration).
Apply the ASSA ABLOY logotype to the cover – see illustration.
Only for SE: Apply the SITAC label next to the product label - see illustration.
25
25
DESIGNATIONART. NO.
YEAR+WEEK
1004083
XXXXXXX XXXXXXXXXXXXX
TYPE
XXXXXXXXXX
TEMPERATURE
XXXXXXXXXXXXXXX
LOAD
XXXXX
PROD. ORDER
XXXXXXX
XXXXXX
XX/XX
Hz
PROJECT/SERIAL NO.
XXXXXXXXXX
W
XXXX
AVAC
ASSA ABLOY Entrance Systems AB
LODJURSGATAN 10
LANDSKRONA SWEDEN
FACTORY NO. X
xxxxxxx
xxxxxxx
1002
SÜD
1 2 3 4 5 6 7 8
CLASSIFICATION DIN 18650
SITAC XXXX
TG XXXXXXX.
Ersätter lås med fallkolv till
typgodkända
slagdörrar enl. förteckning
Skydd mot olyckor vid
rörliga anordningar
67Issue 2021-02-241009728-en-9.0
14 Cover
To Next Page
Loading...
