Assa Abloy SW200 - 11 Mechanical Installation; Surface Mounted Installation

11 Mechanical installation
11.1 Surface mounted installation
The operator is mounted on either side of the door header with two available spindle locations,
LE Performance 95 mm and High performance 210 mm between hinges and outgoing shaft, de-
pending on type of doors.
The door is controlled with a push or pull arm system.
The illustrations also show how to route the cables. If there are sharp edges after drilling the cable
outlets, chamfer the edges to avoid damage to the cables.
Note! Consider all power wire entry locations and signaling wires before preparing back plate.
High performance 210 mmLE Performance 95 mm
C
B
A
B
A
C
135 mmA
250 mmA
654 mmB
613 mmB
14 mmC
32 mmC
8
1
/
4"
1
11
/
16"
40 mm
210 mm
3
3
/
4"
1
11
/
16"
40 mm
95 mm
33Issue 2021-02-241009728-en-9.0
11 Mechanical installation