7
Positioning the Jamb Strike
CAUTION
A
proper frame stop must be used in conjunction with the door/exit device
or damage may occur.
NOTE: The jamb strike must be properly located and tightened securely for
the device to properly operate.
1. PERFORM the following to position the jamb strike.
a. POSITION the strike assembly so the “starwheel” bolt fully
interlocks around the strike when the door is closed.
b. LOOSEN the mounting screws, as necessary, to adjust the
horizontal positioning.
c. WHEN proper positioning is achieved,
THEN TIGHTEN the mounting screws securely.
To Next Page
Loading...
