8
ENTR™ User Manual
• Assemble the cylinder into the door unit (baseplate & knob).
• Tighten the cylinder's
screw.
• Connect the data cable plug.
• Assemble electrical unit as illustrated.
• Tighten the electrical unit's panel screw.
Note: Verify that the cylinder and the knob are
engaged. Press the knob and turn. If the knob can not
be pressed or turned, disassemble the cylinder, adjust
the cylinder's
rectangle and reassemble.
• Verify that the rectangle driver (cylinder) aligned with the knob's rectangle bore.
If required, turn the rectangle driver (cylinder)
it is in the same (see
below).
Knob back view
• Verify the knob is in zero Knob marks point upwards (see page 6).
screw
Driver
Data cable
1
2
Knob back view
To Next Page
Loading...
