7
ENTR™ User Manual
• the magnet on the front panel of the door frame, as close as possible to
the lock.
• The top point of the magnet should be approximately 20mm below the M5 screw
(see
• Use the supplied double-sided to adhere magnet.
Note: The magnet area on door frame should be clean and free from dust, peeling
paint etc. If required use alcohol to clean. Wait
completely dry prior to
• Insert the key into the external side of the cylinder and turn one full turn.
• Take the key out.
Note: Verify that the gear is not pressed in.
Gear not pressed in
Note: Follow the only if the cylinder was dismantled from the door unit.
Magnet
Door frame
Cylinder
screw (M5)
20
To Next Page
Loading...
