16 1-800-810-WIRE • www.sargentlock.com • A8011H
Copyright © 2016, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
04/30/16
Passport 1000 P2 Mortise Lock
11
Install Inside Module Component Assembly
Fig. 13
1. Insert top tabs of controller into slots on mounting plate (Fig. 13).
2. Ensure proper alignment of board-to-board connectors while pivoting
bottom of controller toward door until tab on bottom snaps securely
into place on mounting plate.
CAUTION: To avoid possible damage to board-to-board connectors, care should be
taken when securing controller to mounting plate. If there is resistance when
securing, detach controller to determine cause before re-attaching controller.
To Next Page
Loading...
