Assa Abloy SW300 - PUSH Arm System Mechanical Installation

Assa Abloy SW300

94 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

11.1 PUSH arm system

Reveal

41Issue 2021-02-041007913-en-20.0

11 Mechanical installation

Table of Contents

Default Chapter3
- Table of Contents3
1 Revision7
2 Instructions for Safe Operation8
3 Important Information9
- Intended Use9
- Safety Precautions9
- Electronic Equipment Reception Interference9
- Environmental Requirements10
4 Technical Specifications11
- Permitted Door Weight and Door Width for ASSA ABLOY SW30012
- Permitted Door Weight and Door Width for ASSA ABLOY SW15013
5 How the ASSA ABLOY SW300 and ASSA ABLOY SW150 Work14
- Opening15
- Closing15
- Control Switch15
  - OFF/AUTO/OPEN Switch15
- Functions on the Basic Control Unit CU-30015
- Functions on the Extension Unit EXU-SI17
- Functions on the Extension Unit EXU-SA19
6 Models21
- Single Operator, Surface Mounted21
- Double Operator, Surface Mounted22
7 Part Identification23
8 Arm Systems25
- Pushing Installation with PUSH-Arm25
- Pulling Installation with PULL-Arm26
- MM Extension26
- Pushing Installation with PULL-Arm27
- Double Acting Kits28
- Drive Shaft Extension Kits29
9 Options30
- Control Switches30
  - 4-Position Switch PS-4C (Operates the Electric Lock)30
- Sync Cable for Double Doors (Synchronizing of 2 Operators)30
- Coordination Unit (Only for ASSA ABLOY SW300)30
- LED Cable31
- Battery Backup Unit31
- Cover Piece Kit31
- Closing Time Board Kit (Only for ASSA ABLOY SW300)31
- Fire Kit (Only for ASSA ABLOY SW300)32
- Mounting Plate (for Reinforcement of Wall)32
- Labels33
10 Pre-Installation34
- General Tips/Safety Concerns34
- Operator/Door Handing34
- Installation Examples35
- Fastening Requirements (but Not Included)35
- Tools Required36
11 Mechanical Installation37
- PUSH Arm System41
- PULL Arm System47
- Operator with Sliding PUSH Arm System53
- ASSA ABLOY SW300 Inverse Installation with PUSH Arm System54
- ASSA ABLOY SW300 Inverse Installation with PULL Arm System55
- Installation of Coordination Unit on Fire Door Installations56
12 Electrical Connection62
- Control Units64
- How to Cut the Jumper on the Sync Cable for Double Doors68
- Double Door Installations69
- Settings for Double Doors69
- Sensor Cable Inlet70
- Reset and Indication Device for Fire Doors71
13 Start-Up73
- ASSA ABLOY SW300 Spring Pre-Tension73
- Micro Switch (Only for ASSA ABLOY SW300)74
- Adjusting the Door Stop74
- Auto-Learn-Automatically Sets Back and Latch Check (Recommended)76
  - Push the LEARN BUTTON (LRN)77
  - Double Doors77
- General Adjustment77
- Connection of Activation Units and Accessories78
14 Cover79
- Fitting and Removing the Cover79
- Cover Piece Kit79
15 Signage80
16 Advanced Settings81
- Learn with Advanced Setting of "Back- and Latch-Check81
- Revert to Default Values for "Back- and Latch-Check" (Level 1)81
- Changing Group of Parameters (Level 2)82
- Classification (Level 3)85
- Overhead Presence Detection and Interlock (Level 4)86
- Enhanced Lock Kick, Fire Input and Extended Arm Selection (Level 5)87
17 Guide for Installation and Adjustments88
- Complementary Safety Devices Swing Doors88
- Swing Doors Opening and Closing Time88
  - How to Find the Correct Opening and Closing Time88
- Diagrams for Door Weight89
  - Aluminium Frame with Glass89
18 Troubleshooting90
- Error Indication91
19 Service/Maintenance92

Related product manuals

Preview: Assa Abloy Besam SW100

Assa Abloy Besam SW100

Preview: Assa Abloy Besam SW300

Assa Abloy Besam SW300

Highlands HI1000 - HI2000 - HI3000

Norton D6001DE-R Double Unit Series

Preview: Assa Abloy Besam PowerSwing CSDB

Assa Abloy Besam PowerSwing CSDB

Assa Abloy Albany RR1000

Preview: Assa Abloy Norton D6061 Series

Assa Abloy Norton D6061 Series

Preview: Assa Abloy Norton D6021 Series

Assa Abloy Norton D6021 Series

Preview: Assa Abloy SW60

Assa Abloy SW60

Preview: Assa Abloy SW100

Assa Abloy SW100

Preview: Assa Abloy SW200

Assa Abloy SW200

Preview: Assa Abloy Besam SW200i US

Assa Abloy Besam SW200i US