Associated Electrics RC10 B44.2 - Differential Assembly; Differential Build - Step 1; Differential Build - Step 2

4
:: Front and Rear Differential Build - Step 1
:: Front and Rear Differential Build - Step 2
-1/8
-5/8
-1/2
-3/8
0
-1/4 -3/4
5/64” hex wrench
installed in diff bolt
Fully
tightened
position
Kit
Setting
Racer’s Tip:
Ensure there is no side to side
play of the diff in the gear case.
If too tight, remove one shim
behind the diff gear and adjust
accordingly after several runs.
Trim any flashing
material off of the
#2330 Locking
t-nut ears!
!
6575
Diff
bolt
cover
Build two
diffs!
!
!
#6588
black grease
3911
Outdrive
shim
3976
Outdrive
bearing
3/8x5/8
6574
Diff thrust
balls, 5/64
6582
Diff
spring
2330
Locking
t-nut
6573
Thrust
washers
6573
Thrust
bolt
x9
x2
x6
x2
-1/4
Diff thrust
balls, 5/64
x6x6
x2
x2
6909
Bearing
3/16x5/16
3914
Bevel
diff gear
9734
Outdrive,
long
9734
Outdrive,
short
6579
Diff
outdrive
ring
6579
Diff
outdrive
ring
6581
Carbide
Diff balls
x12
#6591
diff lube
#6591
diff lube
#6591
diff lube
6909
Bearing
3/16x5/16