15
Fig. 44
Fig. 45
❑ Figs. 46 & 47 Go back to the kit master bag and
remove the bearing bag. Inside the bearing bag you will find one
#7359 ¼” x 3/8” unflanged ball bearing, four #897 ¼” x
3/8” flanged ball bearings and four #3656 1/8” x 5/16” unflanged
ball bearings. Take two #897 bearings and insert one into each
#4350 adapter as shown.
Fig. 46
Fig. 47
REAR AXLE ASSEMBLY
❑
Fig. 48 Open bag #5 and remove the #4460 75 tooth
48 pitch spur gear and the bag containing the six #3432 1/8” diff
balls. Now go to the master bag and remove the tube of #6636
Associated diff lube. Look at the center of the spur gear. You will
see two rings of holes. Use the inner ring of holes and fill each
of the six holes with #6636 diff lube. Now press the #3432 balls
into the same six holes. Use your finger to push the diff lube that
pushed out back into the hole.
Fig. 48
❑ Fig. 49 Now we can assemble the rear axle. Take out
the #4456 Assoc. II graphite rear axle, two #6579 Assoc. drive
rings, and the #4458 Assoc. II right diff hub spacer. The #4459
Assoc. II Belleville washer, and the #4185 8-32 nylon locknut
from bag #5. From the bearing bag remove the #7359 ¼” x 3/
8” unflanged ball bearing.
To Next Page
Loading...