LUBRICATION
39 AU104488 C6B
GREASE FITTINGS LOCATIONS
Service grease fittings every 10 hours of operation or
once each day.
Trencher Boom Pivot
RT160072
Trencher Boom Pivot Bearing .............................1 Fitting
The trencher boom pivot grease fitting is accessible from
above by opening the engine access hood, and through
the access opening on the left side of the trencher frame.
IMPORTANT:
Use hand grease gun only. Actuate the
hand pump 5 times. Raise and lower the boom 3 or 4
times and add grease again. Repeat this procedure until
you see new grease at the seals. Add grease slowly to
prevent damage to the seals.
Service the front axle grease fitting every 10 hours of
operation or once each day.
Front Tire Axle
RT160086
Front Tire Axle ..................................................1 Fitting
To Next Page
Loading...
Need help?
General
