LUBRICATION
45 AU104488 C6B
IMPORTANT:
DO NOT use a filter strap wrench to
tighten the filter. A strap wrench can cause a leak if the
filter is dented.
4. Install the filter. Use your hands to tighten filter 1/2
to 3/4 turn after the filter makes contact with the
filter head.
5. Start the engine and run the engine at idle for
approximately 1 minute. Check for leaks.
6. Stop the engine and remove the key.
7. Check the hydraulic reservoir fluid level.
8. Reinstall the hydraulic access cover.
Changing the Hydraulic Oil
Change the hydraulic fluid every 1,000 hours of operation
or once each year, whichever occurs first.
If possible, drain reservoir when hydraulic fluid is warm.
RT160071
1. Clean the area around the filler cap (1) and remove
from fill tube.
RT160068
2. Position a drain funnel and remove the drain plug
(2).
3. Drain the fluid. Make sure a reservoir of sufficient size
(26.11 L, 6.9 U.S. Gal) is used to catch the fluid.
4. See Hydraulic Return Line Filter in this manual and
replace the return filter.
5. Reinstall the drain plug.
6. Fill the reservoir with hydraulic fluid.
NOTE:
See Fluids in this manual for the hydraulic fluid
specifications.
7. Clean the filler cap with solvent. Install the filler
cap.
8. Start the engine. Run the engine at idle for
approximately 2 minutes. Check for leaks.
9. Stop the engine. Remove the key
10. Check the hydraulic reservoir oil level.
WARNING:
Replace all covers or guards after
servicing or cleaning the machine. NEVER
operate the machine with covers or guards
removed
1
2
To Next Page
Loading...
