ASTEC RT160 - AFTER DELIVERY CHECK; After First 50 Hours of Operation of New Machine

B1 AU104488 C6B
AFTER DELIVERY CHECK
AFTER DELIVERY CHECK
After First 50 Hours of Operation of New Machine
Date of Check________________Hourmeter Reading__________________________________________ hours
MACHINE: Product Identification Number ________________________________________________________
OWNER: Name ______________________________________________________________________________
Address ______________________________________________________________________________
DEALER:Name ______________________________________________________________________________
Address ______________________________________________________________________________
DEALER: Make sure the new owner/operator understands all the safety and information decals, the service
information, and the service procedures in this operator’s manual.
Technician (signature) ___________________________________________ Date ________________________
Dealer (signature) ______________________________________________ Date ________________________
Owner (signature) _____________________________________________ Date ________________________
Dealer Copy
TRENCHER PLANETARY
[ ] Check trencher planetary oil level.
ELECTRICAL SYSTEM
[ ] Check battery fluid level.
[ ] Check operation of starter, alternator, and instruments.
ENGINE
[ ] Check engine speed at idle and at full throttle.
FUEL SYSTEM
[ ] Drain water and sediment from the fuel system.
HYDRAULIC SYSTEM
[ ] Change the hydraulic filters.
[ ] Check the reservoir fluid level.
LUBRICATION
[ ] Lubricate all pivot points.
SAFETY
[ ] Check condition of safety decals and information decals.
[ ] Make sure the Operators Manual and Safety Manual
are in the manual storage box.
TIRES
[ ] Check air pressure.
[ ] Check torque for wheel nuts.
WHEEL DRIVE PLANETARIES
[ ] Check fluid level of the wheel drive planetaries.
BOLT TORQUE
[ ] See Bolt Torque in this manual and check the torque
of the bolts shown.