1.3 Electrical Safety
Determine voltage of this equipment before installation and
confirm compatibility with available power. Equipment must be
connected to a properly grounded circuit and installed in
accordance with all applicable electrical codes. Ground fault
protection must be provided in supply circuitry at site installation.
Models designed to EN60204-1: 1997 require power cords be
approved to a harmonized (HAR) standard and rated for 70 °C
(158 °F). A HAR approved Type B plug and strain relief for power
cord is required to meet standard IEC 309. Power conducting wires
must be nominal 5.3 mm
2
(10 AWG) maximum and nominal
2.1 mm
2
(14 AWG) minimum.
1.4 Emergency Power Disconnect
In the event of a malfunction, turn off power to the equipment at
the power off switch and remove source power to the system at the
nearest main disconnect.
1.5 Follow Directions
Read the product manual thoroughly before installation, operation
or maintenance. Failure to do so can result in a serious accident or
equipment malfunction. The manufacturer will not be held
liable for injuries or damage caused by misuse of this
equipment.
1.6 Safety Symbols and Signal Words
The following safety symbols and signal words are used
throughout the manual and on the product to alert the reader and
operator to personal safety hazards or to identify conditions that
may result in equipment or property damage.
WARNING: Indicates a hazard, which, if not
avoided, can result in serious injury, or equipment
and property damage.
CAUTION: Indicates a hazard, which, if not
avoided, can result in minor injury, or equipment
and property damage.
DANGER: Indicates a hazard, which, if not
avoided, will result in serious injury, including
death, or equipment and property damage.
!
!
!
2 KB30, KB50 and KB100 Series Hot Melt Units 19600-159 Rev. A 04/09/09 © Copyright Astro Packaging 2009
To Next Page
Loading...
Need help?
General