10
Chapter 2: Hardware information
2.3 Before you proceed
Take note of the following precautions before you install motherboard
components or change any motherboard settings.
A7N8X
A7N8X Onboard LED
PWR_LED
WARNING
ON
Standby
Power
OFF
Powere
Off
ON
Incorrect
AGP Card
OFF
Correct
AGP Car
CAUTION!
1. Unplug the power cord from the wall socket before touching
components.
2. Use a grounded wrist strap or touch a safely grounded object or to a
metal object, such as the power supply case, before handling
components to avoid damaging them due to static electricity.
3. Hold components by the edges and do not to touch the ICs on them.
4. Whenever you uninstall any component, place it on a grounded
antistatic pad or in the bag that came with the component.
5. Before you install or remove any component, ensure that the
ATX power supply is switched off or the power cord is detached
from the power supply. Failure to do so may cause severe damage
to the motherboard, peripherals, and/or components.
NOTE! When lit, the onboard GREEN LED indicates that the system is
ON, in sleep mode or in soft-off mode, not powered OFF. See the
illustration below. The RED LED warns if the AGP card is incorrectly
installed, or is the wrong type of card for this particular motherboard.
To Next Page
Loading...
Need help?
General
