ASUS A7N8X motherboard user guide
59
Onboard AC97 Audio Controller [Auto]
This field permits auto selection of AC97 audio codec processing by default.
Configuration options: [Auto] [Disabled]
Onboard AC97 Modem Controller [Auto]
This field permits auto selection of AC97 modem support by default.
Configuration options: [Auto] [Disabled]
Onboard Lan (nVIDIA) [Auto]
This field permits auto selection of MAC Lan (nVidia) support by default.
Configuration options: [Auto] [Disabled]
Onboard Lan (3COM) [Auto]
This field permits auto selection of MAC lan (3COM) ethernet. Configuration
options: [Auto] [Disabled]
Onboard 1394 Device [Enabled]
This field sets the on chip suppot for IEEE 1394 signal outputs by default.
Configuration options: [Enabled] [Disabled]
Floppy Disk Access Controller [Enabled]
This field enables the FDA Controller by default. Configuration options:
[Enabled] [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
These fields set the addresses for onboard serial port 1. Serial Port 1 and
Serial Port 2 must have different addresses. Configuration options: [Disabled]
[3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3] [Auto]
Onboard Serial Port 2 [2F8/IRQ3]
These fields set the addresses for onboard serial port 2. Serial Port 1 and
Serial Port 2 must have different addresses. Configuration options: [Disabled]
[3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3] [Auto]
UART use as [COM Port]
This field selects the device assignment for UART2 mode. The default is
[COM Port]. Select [IR] to activate the next field, “UR2 Duplex Mode”.
Configuration options: [IR] [COM Port]
Onboard Parallel Port [378/IRQ7]
This field sets the address of the onboard parallel port connector to 378/
IRQ7 by default. Disabling the port makes the parallel port unavailable.
Configuration options: [Disabled] [378/IRQ7] [278/IRQ5] [3BC/IRQ7]
To Next Page
Loading...
