SAFETY
installation instructions
General
- The connection must comply with national and local
regulations.
- The appliance must always be earthed.
- This appliance may only be connected by a competent
electrical installer.
- The connection cable must hang freely and is not to be fed
through a drawer.
- The worktop the hob is built into must be flat.
- The walls and the worktop surrounding the appliance must
be heat resistant up to at least 85 °C. Even though the
appliance itself does not get hot, the heat of the hot pan
could discolour or deform the wall.
- Damage caused by incorrect connection, installation or use,
will not be covered by the guarantee.
Clearance
Sufficient all-round clearance is essential to the safe use of the
hob. Check that there is enough clearance.
GB 21
HI8071M HI8071I
To Next Page
Loading...
