GB-15
Tank sensor
Versions:
AVB06 Cable length 5 m
Application: Tank sensor (for nearby hot
water generators, buffer
tanks etc.)
Mounting location:
In the designated immersion sleeve of the
corresponding application.
Mounting in DHW- or buffer tanks
Bend the pressing spring towards the
sensor tip and slide the sensor into the dry
immersion sleeve of the corresponding
tank.
Electrical connection
Clamp the sensor to the appropriate
terminal clamps of the respective control
unit (see corresponding connection
diagram). The two-strand connection is
interchangeable.
Flow sensor
Flow sensor VF20
Versions:
VF 20 Cable length 4 m
S4363400
Application: As a flow sensor for unmixed
circuits and mixed circuits of
heating circuits
Mounting location:
Behind the mixer pump at a distance of at
least 50 cm.
Mounting:
Polish the flow pipe and apply heat
conductive paste.
Fasten the sensor to the contact location with
a tensioning belt so that it is flush with the
pipe's surface.
Ensure a tight fitting!
Electrical connection
Clamp the sensor to the appropriate terminal
clamps of the respective control unit (see
corresponding connection diagram). The two-
strand connection is interchangeable.
Tank sensor AVB06
GB
To Next Page
Loading...
Need help?
General