Atag MadQ/2 Installation Manual

GB-22
Operation modes
After entering the information level using the
information key ¤ all available operating
states and usage data
such as counter readings, specified
performance data etc. can be requested one
by one by turning the rotary pushbutton anti-
clockwise.
Information
Example of
display
Function Application
Status
Unmixed circ.
AUTO-P1 ECO
HC ON
Program/3-program/mode
status of heating pump
(..2..)
Status
Mixed circ. 1
AUTO-P1 ECO
MC-1 ON
(..3..)
Status
of
mixing valve
Mixed circ. 1
ACTUATOR-1
OPEN
Display of set direction
OPEN-STOP-CLOS
(..3..)
Status
Mixed circ. 2
AUTO-P1 ECO
MC-2 ON
Program/3-program/mode
status of heating pump
(..33..)
Status
of
mixing valve
Mixed circ. 2
ACTUATOR-2
STOP
Display of set direction
OPEN-STOP-CLOS
(..33..)
Status of boiler
control unit stage 2
HEAT GENER.
ST-2 OFF
Switching condition
of boiler control unit
Stage 2
(..22..)
Status of boiler
control unit
(mod.)
MODULATION
57% 60%
Modulating, continuously
variable boiler control unit,
display of set and actual value
(..VV..)
Status
Tank circuit
AUTO-P1 ECO
DHW ON
Program/3-program/mode
Status of heating pump
(..B..)
Function and status
Unmixed circuit
pump
OUTPUT HC-P
EO ON
Information on the allocated
function and switching condition
of the pump
(..2..)
Function and status
Variable output 1
OUTPUT VO-1
SOP OFF
Information on the allocated
function and switching condition
of the var. output 1
(..VV..)
Function and status
Variable output 2
OUTPUT VO-2
SOP OFF
Information on the allocated
function and switching condition
of the var. output 2
(..VV..)
Explanation of the type designation
- MadQ 23BC
- MadQ 233BVVC
Application:
(2...) an unmixed circuit
(..3..) with one mixed circuit
(..33..) with two mixed circuits
(..B..) domestic hot water circuit
(..VV..) with two variable outputs
(....C) in combination with ATAG boiler control unit with an RS-485 bus.
GB

Atag MadQ/2 Specifications

General

Brand	Atag
Model	MadQ/2
Category	Network Router
Language	English