Atag MC4111L - 9 Test Program Pelgrim solo; Important Instructions; Conditions of Entry; Run of the Test Program

MC4111L / MAG 690
Technische documentatie
9 - TEST PROGRAM PELGRIM SOLO
9.1. - Important instructions
• To place a container filled with water in the oven (for the tests in microwave modes).
• To connect (if possible) an ammeter on the power supply of the oven.
• Entirely execute the test program.
• Record discrepancies noticed as the test program is running.
• Next, check and replace if necessary the incriminated component(s).
• Perform right-operation check by executing the test program.
9.2. - Conditions of entry
• Set the time to 12 : 00
• Press successively 1-2-3-4-3-2 and hold 1, 5 seconds minimum.
9.3. - Run of the test program
Step Run and display Remarks
1
Software checking
• Displaying the software number : 1006
NO ⇒ If connections to power card are OK, then display
card out of order.
Continue the test
2
Software checking
• Displaying the evolution n° of the software.
NO ⇒ If connections to power card are OK, then display
card out of order.
Continue the test
3
Button checking
• Button checking
NO ⇒ If connections to power card are OK, then Button
or display out of order.
Continue the test
4
Right rotary switch checking
• Right rotary switch checking
NO ⇒ If connections to power card are OK, then Right
rotary switch or display out of order.
Continue the test
5
Right rotary switch checking
• Right rotary switch checking
NO ⇒ If connections to power card are OK, then Right
rotary switch or display out of order.
Continue the test
6
Right rotary switch checking
• Right rotary switch checking
NO ⇒ If connections to power card are OK, then Right
rotary switch or display out of order.
Continue the test