Appendix
85
Troubleshooting
I cannot dial out.
f Try all the suggestions, as mentioned above.
f Make sure you have a dial tone before dialing. The cordless
handset may take a second or two to nd the telephone base
and produce a dial tone. This is normal. Wait an extra second
before dialing.
f Eliminate any background noise. Noise from a television, radio or
other appliances may cause the phone to not dial out properly. If
you cannot eliminate the background noise, rst try muting the
cordless handset before dialing, or dialing from another room
with less background noise.
f If other phones in your home are having the same problem,
contact your telephone service provider (charges may apply).
My cordless handset isn’t performing normally.
f Make sure you plug the power cord securely into the telephone
base. Plug the power adapter into a dierent working electrical
outlet without a wall switch.
f Move the cordless handset closer to the telephone base. You
may have moved out of range.
f Reset the telephone base. Unplug the electrical power. Wait for
15 seconds, then plug it back in. Allow up to one minute for the
cordless handset and telephone base to reset.
f Other electronic products such as HAM radios and other DECT
phones, can cause interference with your cordless phone. Try
installing your phone as far away as possible from these types of
electronic devices.
The batteries do not hold a charge.
f Charge the battery in the cordless handset for at least 10 hours.
For optimum daily performance, return the cordless handset to
the telephone base or charger when not in use.
f If the battery is depleted, it may take approximately 30 minutes
to charge the handset before it shows Low battery. Refer to the
table on page 10 for details.
f You may need to purchase a new battery. Please refer to
Battery installation and charging in this user’s manual on
pages 10- 11.
To Next Page
Loading...
Need help?
General
