34
Use the answering system menu of the telephone to set up the
announcement message, message alert, activate call screening, or change the
number of rings, remote access code or priority code.
When the telephone is in idle mode, press
MENU/SELECT to enter the main menu.
Press MENU/SELECT again to select Answering sys.
Announcement
Your outgoing announcement plays when calls are answered by the
answering system.
The telephone has a default outgoing announcement, “Hello. Please leave a
message after the tone.” You can use this announcement, or record your own.
You can record an announcement of up to three minutes. The system does
not record any announcement shorter than two seconds.
To play your current outgoing announcement:
When the telephone is in idle mode, press
MENU/SELECT to enter the main menu.
Press MENU/SELECT again to select Answering sys.
Press CALL LOGq or DIRECTORYp to scroll to
Announcement, then press MENU/SELECT.
Press CALL LOGq or DIRECTORYp to scroll to
Play current, then press MENU/SELECT.
To record a new outgoing announcement:
When the telephone is in idle mode, press
MENU/SELECT to enter the main menu.
Press MENU/SELECT again to select Answering sys.
Press CALL LOGq or DIRECTORYp to scroll to
Announcement, then press MENU/SELECT.
Press CALL LOGq or DIRECTORYp to scroll to
Record new, then press MENU/SELECT. The system
announces, “Record after the tone. Press 5 when you are done.”
Speak towards the telephone to record your announcement. Press 5 to end
recording. Your recorded announcement plays.
To listen to the recorded announcement again, scroll to Play current and
press MENU/SELECT.
1.
2.
1.
2.
3.
4.
1.
2.
3.
4.
5.
Answering system settings
Answering system
>Answering sys
Directory
q
>Announcement
Delete all old
q
Record new
>Play current
p
q
>Record new
Play current
q
To Next Page
Loading...
Need help?
General
