You can follow the voice guide to record your own announcement, set the number of rings and set the
message alert tone.
1. . MENU -> or -> Answering sys -> SELECT.
2. or -> Voice guide -> SELECT.
3. Set up the answering system by inputting the designated numbers, as instructed.
Record your own announcement
Your outgoing announcement plays when calls are answered by the answering system. You can use
the preset announcement to answer calls, or replace it with your own recorded announcement.
1. MENU -> or -> Answering sys -> SELECT.
2. SELECT to select Announcement.
3. SELECT to select Record annc.
4. Facing the handset, record your announcement and press 5 to end recording.
Number of rings
You can set the answering system to answer an incoming call after 2, 3, 4, 5, or 6 rings. You can also
select toll saver. If you choose toll saver, the answering system answers a call after two rings when
you have new messages, and after four rings when there are no new messages. This enables you to
check for new messages and avoid paying unnecessary long distance charges if you are calling from
out of your local area.
If you want the built-in answering system instead of the voicemail to answer a call, you should set the
answering system to answer a call at least two rings before the voicemail is set to answer. Contact
your telephone service provider for information on your voicemail settings.
1. MENU -> or -> Answering sys -> SELECT.
2. or -> Ans sys setup -> SELECT.
3. or -> # of rings -> SELECT.
4. or to choose among 2, 3, 4, 5, 6, or Toll saver -> SELECT.
Ringer volume
You can set the ringer volume level to one of the six levels, or turn the ringer off.
1. MENU -> or -> Answering sys -> SELECT.
2. SELECT to select Ringer volume.
3. or to choose the desire level -> SELECT.
LCD language
Using a cordless handset or the telephone base:
1. MENU -> / -> Settings -> SELECT.
2. SELECT again to select LCD language.
3. / to choose English, Français or Español -> SELECT.
Note: If you accidentally change the LCD language to French or Spanish, you can reset it back to
English without going through the French or Spanish menus.
Press MENU on the handset in idle mode -> enter 364#; or
To Next Page
Loading...
Need help?
Technical Specifications
Power
Battery
