Operate
Operation: Steps
Making a call: Press PHONE or /SPEAKER -> Enter the telephone number.
On-hook dialing (predialing): Enter the telephone number -> Press PHONE or /SPEAKER to call.
Answering a call: Press PHONE or /SPEAKER, or press any dialing keys (0-9, TONE or #).
Ending a call: Press OFF or return the handset to the telephone base or charger.
Handset speakerphone: During a call, press /SPEAKER to switch between handsfree
speakerphone and normal handset use.
Redial: Press REDIAL repeatedly to select the desired entry -> PHONE or /SPEAKER to call.
Volume control: Press / VOLUME to decrease or press / VOLUME to increase the listening
volume during a call.
Call waiting (Requires subscription from telephone service provider): Press FLASH to put
current call on hold and to take the new call; press again to switch back and forth between calls.
The directory can store up to 50 entries, which are shared by all system devices.
Adding an entry
1. MENU -> or -> Directory -> SELECT.
2. or -> Add contact -> SELECT.
3. Enter a telephone number up to 30 digits -> SELECT.
4. Enter a name up to 15 characters -> SELECT.
Searching/dialing an entry
1. DIR in idle mode.
2. Press or to browse through the directory, or press the dialing keys (0-9) to start a name
search.
3. Press PHONE or /SPEAKER on a handset to call.
Caller ID
This product supports caller ID services offered by most telephone service providers. The telephone
stores caller ID information of the last 50 incoming calls in the telephone base. This information is
common to all devices.
Caller ID announce
When this feature is on and you have an incoming call, the handset and/or base speaks “Call from…”
and the name of the caller based on the directory or caller ID information. You can turn this feature off
for the base or each individual handset, or both.
1. MENU -> or -> Answering sys -> SELECT.
2. or -> Caller ID annc -> SELECT.
3. or to choose Set all On/Off, Local handset or Base -> SELECT.
To Next Page
Loading...
