AT&T E6012B - Day and time announcements

35
Answering system operation
Day and time announcements
To set day and time
Before playing each message, the answering sys-
tem announces the day and time the message
was received.
Before using the answering system, follow the
steps on the left to set the year, time and day, so
messages are dated correctly. If the clock is not
set when the message is recorded, the system will
prompt "Time and day not set."
The system uses voice prompts to guide you. Each
time you press SKIP or REPEAT , the year,
hour, minute or day increases or decreases by one.
When you hear the correct setting is announced,
press CLOCK to move to the next setting.
To check day and time
You can press CLOCK any time to listen to the
current day and time without changing it.
NOTES:
1. Press and hold SKIP or REPEAT to increase or
decrease the minute or year by increments of ten.
2. Caller ID provides the time and date. Set the year so that
the day of the week can be calculated from the caller ID
information. The time will be set automatically only if you
subscribe to caller ID service provided by your local tel-
ephone company (page 19).
1.
Press CLOCK
The system will announce
the current clock setting,
then announces “To set the
clock, press CLOCK”.
3.
Press SKIP
-OR- REPEAT
until the system announces
the correct year, then press
CLOCK.
2.
Press CLOCK
The system will announce
the current year setting, then
announces “To change the
year, press SKIP or REPEAT,
to change the hour, press
CLOCK.”
4.
until the system announces
the correct hour, then press
CLOCK.
Press SKIP
-OR- REPEAT
until the system announces
the correct minute, then
press CLOCK.
5.
Press SKIP
-OR- REPEAT
6.
until the system announces
the correct day, then press
CLOCK. The system announces
the current clock
setting.
Press SKIP
-OR- REPEAT