AT&T E6012B - Changing feature options

37
Answering system operation
1.
SETUP
3.
SETUP
-OR-
Press until the desired
feature is announced
(see list on right).
Press until the
desired selection is
announced.
Press to set selection
and move to the next
menu option.
Press to set selection
and exit the menu.
2.
SKIP or
REPEAT
PLAY/STOP
Changing feature options
You can change how the answering system operates.
Press SETUP repeatedly to listen to each feature. When
the desired feature is announced, press SKIP or
REPEAT to change the setting.
Feature options (Default settings underlined).
System announces: Feature description:
Choose the number of rings
before the system answers a call.
When toll saver is active, the
system answers after two rings
if you have new messages, and
after four rings if you have no
new messages. When retrieving
messages from a different loca-
tion, you may disconnect your
call after three rings so that long
distance charges will not apply.
Pressing any base key (except RECORD, ANSWER ON and
HANDSET LOCATOR) will temporarily silence the message alert
tone. Press and hold DELETE, to delete all old messages and
temporary silence the message alert tone. The message alert tone
will be re-activated with the next incoming message.
"Number of rings", current
setting, then "To change
the setting press SKIP
or REPEAT; to continue
setup, press SETUP"
Options: 2/4/6/toll saver
"Remote access code",
current setting, then "To
change the setting press
SKIP or REPEAT; to con-
tinue setup, press SETUP."
Options: (select a two-
digit code) 19
"Message alert tone",
current setting, then "To
change the setting, press
SKIP or REPEAT; to con-
tinue setup, press SETUP."
Options: on/off
“Base ringer", current
setting, then “To change
the setting, press SKIP
or REPEAT; to continue
setup, press SETUP”
Options: high/low/off
Choose the base ringer volume
between high and low level, or
turn the base ringer off.
Select a two-digit number (10-
99) for remote access from
another telephone (page 42).
NOTE: Press and hold SKIP
or REPEAT to increase or
decrease the remote access code
number by increments of 10.
When on, the telephone beeps
every 10 seconds when there are
new messages.
NOTE: The message alert
tone will beep only if all the condi-
tions below are met:
Answering system is on
Message alert tone setting is on
There are new messages