6
Getting started
LOW BATTERY
Battery installation & charging
After battery installation, the battery may have enough charge to allow for some calls.
For best performance, place the handset(s) in the telephone base or charger(s) and
allow to charge for 16 hours before use.
You can keep the battery charged by returning the handsets to the telephone base or
chargers after each use. When the battery is fully depleted, a recharge takes about 12
hours. The average talk time on a fully charged battery is about eight hours depending
on environmental conditions, and the standby time is approximately three days. Actual
battery life will depend on usage conditions and age of battery.
Caution: Use only the supplied battery or rechargeable battery (model 27910, part
number 89-0099-00-00) or equivalent. To order a replacement battery, call 1 (800) 222-3111,
in Canada dial 1 (866) 288-4268 or visit our website at www.telephones.att.com.
To replace the battery, press in and
downward on the tab to open the bat-
tery compartment cover. Then lift out
the old battery and disconnect. Follow
the instructions on this page to install
and charge the new battery.
3. Slide battery com-
partment cover towards
the center until it clicks
closed.
Low battery indicator
Return handset to the telephone
base or charger to recharge when
this symbol flashes, the handset
screen is dim or completely clear.
(Handset will beep when battery is
low.)
2. Place the battery
pack and wires inside
the compartment.
1. Plug the battery securely
into the plug inside the
handset battery compart-
ment, matching the color-
coded label.
To Next Page
Loading...
