AT&T E6012B - Telephone base and charger installation

5
Getting started
NOTES:
1. Use only the power cord supplied with this product, if you need a replacement, call 1 (800)
222-3111, in Canada dial 1 (866) 288-4268. Or visit our website at www.telephones.att.com.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be plugged into a vertical wall outlet or a floor outlet. The
prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-
table or cabinet outlet.
4. If you receive high speed internet through your telephone line (coming referred to as DSL),
and you are experiencing inference during telephone conversations and/or your caller ID fea-
tures are not functioning properly, install a DSL filter to the telephone line between the tel-
ephone base and the telephone wall jack. Contact your DSL service provider for a DSL filter.
Telephone base and charger installation
1. Plug the small end of the smaller power
adapter into the jack on the underside of
the charger, then route the cord through
the slot as shown.
2. Plug the large end of the smaller power adapt-
er into an electrical outlet.
Telephone line cord
DSL filter
(Optional for DSL us-
ers, see number four
in the note section,
below.)
5. Plug the other end of
the telephone line cord
into a telephone jack.
4. Plug the large
end of the larger
power adapter into
an electrical outlet
not controlled by a
wall switch.
3. Route cords
through slots.
1. Plug one end of the telephone line
cord into the telephone jack at the
bottom of the telephone base.
2. Plug the small end of the larger power adapter into
the power jack at the bottom of the telephone base.