26
Adding and registering cordless handsets/headsets/speakerphones
Your telephone system can support up to ve cordless handsets, headsets or
speakerphones (sold separately). The handsets provided within your product package
are already registered as HANDSET 1, and so forth. You can purchase additional handset
AT&T EL50005 to expand your telephone system.
To register a cordless headset or speakerphone to this telephone system, please refer
to the corresponding user’s manual for details. To register a cordless handset, see below.
Additional handsets are assigned numbers in the sequential order they are registered
(up to HANDSET 5). Each handset must be registered to the telephone base before use.
Register a handset to the telephone base:
1. Before you begin registration, make sure the
handset is out of the telephone base or charger
and shows To register HS... and
...see manual, alternately.
2. Put the handset you wish to register on the
telephone base cradle.
3. The light on the telephone base turns
on. Aer about 10 seconds, the handset shows
Registering.... The handset shows Registered
and you hear a conrmation tone if the
registration was successful. The light
turns o. The handset is now registered with
the telephone base.
If the registration fails, the handset displays Reg. failed and then To register HS... and
...see manual, alternately. Try the registration again by removing the handset from the
telephone base and then placing it back in.
NOTES:
• You cannot register a handset if any other system handset is in use.
• You can only register one handset to the telephone base at a time.
For registration, put the handset on the
telephone base, not the handset charger.
To Next Page
Loading...
Need help?
General
