40
Answering system settings
Answering system settings
Announcement
The announcement is the greeting callers hear when calls are answered by
the answering system.
The telephone has a default announcement, “Hello. Please leave a message
aer the tone.” You can use this announcement, or record your own
announcement.
You can record an announcement up to 90 seconds. The system does not
record any announcement shorter than two seconds.
To play the current announcement:
Press MENU/SELECT in idle mode.
Press DIR or CID to scroll to >ANSWERING SYS, then
press MENU/SELECT.
Press MENU/SELECT to choose >ANNOUNCEMENT. The
system announces, “To play, press 2. To record, press 7.”
Press 2 to play the current announcement from
the speakerphone.
Press DIR/VOLUME to increase or press
CID/VOLUME to decrease the message
playback volume.
Press
SPEAKER to switch between speakerphone
and handset earpiece.
To record a new announcement:
Follow Steps 1 and 2 in To play the current announcement on this page.
Press MENU/SELECT to select >ANNOUNCEMENT. The system announces,
“To play, press 2. To record, press 7.”
Press 7. The system announces “Record aer the tone.
Press 5 when you are done.”
Face the handset and speak towards the microphone to
record your announcement.
Press 5 when you nish the recording. The handset plays
back the recorded announcement.
NOTE: If the answering system memory is full, when you press 7 in Step 3, the answering
system announces, “Memory is full.” You must delete some messages before you can record a
new announcement. Refer to Message playback on page 46.
1.
2.
3.
4.
•
•
1.
2.
3.
4.
5.
>ANNOUNCEMENT
DELETE ALL OLD
2-PLAY 3-DELETE
5-STOP 7-RECORD
RECORD ANNC...
5-STOP
To Next Page
Loading...
Need help?
General
