AT&T EL52210 User Manual

58
Appendix
Troubleshooting
Make sure you have a dial tone before dialing. The cordless handset may
take a second or two to nd the telephone base and produce a dial tone.
This is normal. Wait an extra second before dialing.
Check that all the telephones connected to the same telephone line are
hung up.
Make sure to set the dial mode to the correct setting (pulse dialing or tone
dialing) for the service in your area (see Dial mode on page 14).
Eliminate any background noise. Noise from a television, radio or other
appliances may cause the telephone not to dial out properly. If you cannot
eliminate the background noise, rst try muting the cordless handset
before dialing, or dialing from another room in your home with less
background noise.
If the other telephones in your home are having the same problem, the
problem is in your wiring or telephone service. Contact your telephone
service provider (charges may apply).
My cordless handset isn’t performing normally.
Make sure the power cord is securely plugged into the telephone base.
Plug the power adapter into a dierent, working electrical outlet not
controlled by a wall switch.
Move the cordless handset closer to the telephone base. You might have
moved out of range.
Reset the telephone base. Unplug the electrical power. Wait for 15 seconds,
then plug it back in. Allow up to one minute for the cordless handset and
telephone base to reset.
Other electronic products can cause interference to your cordless
telephone. Try installing your telephone as far away from these types
of electronic devices as possible: television sets, VCRs, or other cordless
telephones.
OUT OF RANGE OR NO PWR AT BASE appears on my cordless handset.
Ensure that the telephone base is powered on.
Place the cordless handset in the telephone base for one minute to allow
the cordless handset and base to synchronize.
Move the cordless handset closer to the telephone base. You might have
moved out of range.
Reset the telephone base. Unplug the electrical power. Wait for 15 seconds,
then plug it back in. Allow up to one minute for the cordless handset and
telephone base to reset.
Other electronic products can cause interference to your cordless
telephone. Try installing your telephone as far away from these types
of electronic devices as possible: television sets, VCRs, or other cordless
telephones.
•
•
•
•
•
•
•
•
•
•
•
•
•
•

AT&T EL52210 Specifications

General

Brand	AT&T
Model	EL52210
Category	Cordless Telephone
Language	English