EasyManuals Logo

AT&T EL52210 User Manual

AT&T EL52210
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
63
Appendix
Troubleshooting
If the caller pauses for longer than seven seconds, the answering system
stops recording and disconnects the call.
If the answering system’s memory becomes full during a message, the
answering system stops recording and disconnects the call.
If the caller’s voice is very so, the answering system may stop recording
and disconnects the call.
If someone picks up the call at a telephone on the same line during a
message, the answering system stops recording and disconnects the call.
Part of the message may be lost.
Diculty hearing messages.
Press
VOLUME to adjust the speaker volume on the telephone base.
Press DIR/VOLUME to increase the message playback volume on a handset.
The answering system does not answer aer correct number of rings.
Make sure the answering system is on. When the answering system is on,
ANS ON should show on the handset and the
ANSWER ON/OFF light is
lit on the telephone base (see Answering on/o on page 39).
If toll saver is selected, the number of rings changes to two when there are
new messages (see Number of rings on page 41).
If the memory is full or the answering system is o, the answering system
answers aer 10 rings.
In some cases, the answering system is aected by the ringing system
used by the telephone service provider.
If you subscribe to voicemail service, change the number of rings so that
your answering system answers before your voicemail (see Answering
system and voicemail on page 43). To determine how many rings activate
your voicemail, contact your telephone service provider.
If there is a fax machine connected to the same telephone line, try
disconnecting the fax machine. If that solves the problem, consult your
fax machine documentation for information on compatibility with
answering systems.
The answering system announces Time and date not set.
You need to reset the date and time (see Set date/time on page 13).
The answering system does not respond to the remote commands.
Make sure to enter your remote access code correctly (see Remote access
on page 51).
Make sure you are calling from a touch-tone telephone. When you dial a
number, you should hear tones. If you hear clicks, the telephone is not a
touch-tone telephone and cannot activate the answering system.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AT&T EL52210 and is the answer not in the manual?

AT&T EL52210 Specifications

General IconGeneral
BrandAT&T
ModelEL52210
CategoryCordless Telephone
LanguageEnglish

Related product manuals