Features
Calling Group Message
Receiver
Your system manager can program a calling group to receive
messages and choose a particular display telephone as the
message receiver. Any display telephone, such as your
telephone, an agent telephone, or the telephone of a
co-worker who is not part of the group, can be chosen to be
the message receiver. Calling groups can share the same
message receiver.
The system operator
display message for
or any other inside caller can leave a
the group. Inside callers waiting in the
calling group queue can leave a message by dialing-the
feature code for leaving a message (pressing
Feature
and
dialing
53,
followed by the calling group’s extension number.
The system operator can leave a message by using either the
feature code or the
Send/Remove Message
button on his or
her console.
The designated message receiver’s message lamp will light if
there is a voice mail message in the calling group’s mailbox.
A calling group without a message receiver cannot receive
messages at the calling group’s extension. A caller who tries
to leave a message hears an error tone or sees
Can’t
Send/Remove Message
on a display telephone.
Calling Group Message Receiver
3-3
To Next Page
Loading...
