AT&T MF279 - Using Calling Features; Making and Managing Calls

Using Your Device
Calling
Making Calls
Using a phone connected to your AT&T Wireless Internet device, place and receive
calls as you normally would. The AT&T Wireless Internet device supports dialing with
either a cordless or corded phone.
NOTE: Make sure to dial the 10-digit phone number, including area code.
Placing a Call on Hold
While on a call, you can press the Flash (or Phone/Talk) key to put the other party
on hold.
Three-Way Calling
Initiate a Three-Way Call
1. While on a call, press the Flash (or Phone/Talk) key to put the rst party on hold.
2. When you hear a dial tone (wait up to four [4] seconds), dial the second number.
3. When the second party answers, press the Flash (or Phone/Talk) key again to
complete the three-way connection. If the second party does not answer, press the
Flash (or Phone/Talk) key to end the connection and return to the rst party.
Call Waiting
You will hear two tones if someone calls while you are already on a call. When this
happens, you have several options:
• To hang up on the rst call and connect the incoming call, press the 1 key and then
the Flash (or Phone/Talk) key.
• To continue the rst call and reject the incoming call, press the 0 key and then the
Flash (or Phone/Talk) key.
• To place the rst call on hold and connect the incoming call, press the 2 key and
then the Flash (or Phone/Talk) key.
14