Internet Access
Connect Other Devices
You can simultaneously connect up to ten (10) devices per Wi-Fi network (2.4 GHz
and 5 GHz), twenty (20) total, including smartphones, tablets, and laptops, to your
AT&T Wireless Internet device.
1. Open the Wi-Fi network manager on your Wi-Fi enabled device.
2. Find and select the Wi-Fi network name (SSID): ATT-WI-XXXX or
ATT-WI-XXXX-GUEST (guest network disabled by default).
NOTE: The AT&T Wireless Internet device supports both 2.4 GHz and 5 GHz Wi-Fi
networks. You can simultaneously connect up to ten (10) Wi-Fi enabled devices on
each network.
3. When prompted, enter the Wi-Fi password found on the bottom of the
AT&T Wireless Internet device.
Connect WPS Devices
Wi-Fi Protected Setup (WPS) allows WPS-enabled devices to be connected to a Wi-Fi
network without having to type a Wi-Fi password.
1. With the AT&T Wireless Internet device powered on, press and hold the WPS button
for one (1) second.
2. Within two (2) minutes, press the WPS button on the wireless device you want
to connect.
3. Your AT&T Wireless Internet device and the wireless device will communicate and
establish the connection.
Connect via Ethernet
To connect via Ethernet, plug one end of your Ethernet cable in to the Ethernet
port on your computer and the other end in to the Ethernet port on the back of the
AT&T Wireless Internet device.
16
To Next Page
Loading...
