AT&T SB67118 DECT 6.0 - Hold Reminder; Set Date and Time

The answering system displays the date and time of the message while
playing messages. Before using the answering system, set the date and time
as follows. If you subscribe to caller ID service, the day, month and time are
set automatically with each incoming call. The year must be set so that the
day of the week can be calculated from the caller ID information.
Follow the steps below to set the month, day, year and time:
When the telephone is idle, press MENU/ENTER.
Press or to scroll to Base setup. Press MENU/ENTER.
Press or to scroll to Date and time. Press MENU/ENTER.
Using the dial pad to enter the date. Press REP or
SKIP to scroll to the item you want to edit, and press
the dial pad keys to enter the correct digit.
Press to move to the time editing.
Press or to select AM or PM.
Press REP or SKIP to scroll to the item you want to
edit, and press the dial pad to enter the correct digit.
8. Press MENU/ENTER to save the setting and return to
the previous menu. There is a confirmation tone. To exit without making
changes, press EXIT.
1.
2.
3.
4.
5.
6.
7.
Hold reminder
Use this feature to have silence or play a beep tone every 30 seconds when
there is a call on hold.
When the telephone is idle, press MENU/ENTER.
Press or to scroll to Base setup. Press MENU/ENTER.
Press or to scroll to Hold reminder. Press MENU/ENTER.
Press or to scroll to On or Off.
Press MENU/ENTER to save the setting and return to
the previous menu. There is a confirmation tone. To exit
without making changes, press EXIT.
1.
2.
3.
4.
5.
Line selection
Set line mode
Area codes
Hold reminder
>
Hold reminder
:On
ENTER=Save
Set date and time
Set line mode
Area codes
Hold reminder
Date and time
>
Date: 12.31. 2006
Time: 09:00 AM
^v=PM
ENTER=Save
Date: 01.01. 2009
Time: 12:00 PM
^v=AM
ENTER=Save
Getting started
Telephone base setup
22
Flashing