AT&T SB67118 DECT 6.0 - Telephone Base Operation; Telephone Base Basic Operation; Line Indicators; Making a Call

The telephone comes programmed to use line 1 (default primary line) for
calls when you do not press a line key. (To change the primary line, see
Line selection on page 20.) When you answer a call, the telephone
automatically selects the ringing line.
Line indicators
Each of the four indicators on LINE 1-LINE 4 indicate the state of the
corresponding telephone line.
On when the corresponding line is in use.
Flashes slowly when the line is on hold.
Flashes slowly when there is a transferred call on the
corresponding line.
Flashes slowly when there is an incoming auto attendant transferred call
on the corresponding line.
Flashes rapidly when there is an incoming call on the corresponding line.
Making a call
To make a call from the telephone base:
Lift the handset or press SPEAKER.
-OR-
To override automatic line selection, press LINE 1-LINE 4 for the desired
line, then lift the handset.
2. Wait for a dial tone, then enter the telephone number.
The screen displays the elapsed time as you talk
(in hours, minutes and seconds).
To end a call from the telephone base:
Place the handset on the telephone base to hang up.
-OR-
If you are using the speakerphone, press SPEAKER to hang up.
NOTE: The elapsed time is not affected by accessing services from your telephone
service provider.
•
•
•
•
•
1.
Line1 00:00:27
8888832445
Elapsed time
Telephone base operation
Telephone base basic operation
38
On