Getting started
Mailbox setup (for handset)
33
Fast answer mode
You can change the fast answer mode setting of your handset mailbox from
the telephone base. The number of rings can be two (on) or five (off). The
default is five rings. Please see Fast answer mode on or off in the SB67108
handset manual for more information.
When the telephone is idle, press Messages on the
telephone base.
Press the one-touch EXT 1-0 key for the destination
extension mailbox.
Use the dial pad to enter the four-digit remote access
code of the extension. Use REMOVE to backspace and
delete a digit. Press MENU/ENTER.
Press or to scroll to Fast answer mode.
Press MENU/ENTER.
Press or to select On or Off.
Press MENU/ENTER to save the setting and return to
the previous menu. There is a confirmation tone. To exit without making
changes, press EXIT.
1.
2.
3.
4.
5.
6.
You can access handset mailboxes from the telephone base. Please see
Handset mailbox overview in the SB67108 handset manual.
2 New messages
Handset anncemnt
To general MBox
Fast answer mode
>
Enter mailbox
access code:
0001
ENTER=Next
Fast answer mode
:On
ENTER=Save
Handset announcement setup
You can set or change the handset announcement from the telephone base.
The announcement is the greeting callers hear when calls are answered by
the handset mailbox.
The handset has the pre-recorded announcement “Hello, please leave a
message after the tone.” You can use this announcement, or replace it with
your own recording.
Your announcement can be up to two minutes.
When the telephone is idle, press Messages on the telephone base.
Press the one-touch EXT 1-0 key for the destination extension mailbox.
Use the dial pad to enter the four-digit remote access code of the
extension. Use REMOVE to backspace and delete a digit.
Press MENU/ENTER.
Press or to scroll to Handset anncemnt. Press
MENU/ENTER.
1.
2.
3.
4.
2 New messages
Play all
Deliver
Handset anncemnt
>
To Next Page
Loading...
