81
Answering system
Answering system settings
Number of rings
You can set the answering system to answer an incoming call after two, three,
four, five, or six rings. You can also select toll saver, which is explained below.
By default, the answering system answers an incoming call after four rings.
To set the number of rings:
Press MENU in idle mode.
Press CID or DIR to highlight Answering sys, then press
SELECT.
Press CID or DIR to highlight Ans sys setup, then press
SELECT.
Press CID or DIR to highlight # of rings, then press
SELECT.
Press CID or DIR to choose from 6, 5, 4, 3, 2 or
Toll saver.
Toll saver - the answering system answers a call after
two rings when you have new messages, or after four rings when
there are no new messages. This feature allows you to check for new
messages and avoid paying long distance charges when calling from
out of your local area.
Press SELECT to confirm. You hear a confirmation tone.
NOTE: If you set the number of rings for the answering system as 2 or 3 rings, the caller
ID announce feature may not have enough time to announce the caller’s
full information.
1.
2.
3.
4.
5.
•
6.
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK
SELECT
# OF RINGS
6
5
4
BACK
SELECT
To Next Page
Loading...
