83
Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. The tone stops when all
new messages have been reviewed. By default, the message alert tone setting
is Off.
To change the setting:
Press MENU in idle mode.
Press CID or DIR to highlight Answering sys, then press
SELECT .
Press CID or DIR to highlight Ans sys setup, then press
SELECT .
Press CID or DIR to highlight Msg alert tone, then press
SELECT .
Press CID or DIR
to choose between On and Off, then
press SELECT.
NOTES:
To temporarily turn off the message alert tone, see page 87.
The message alert tone beeps only if all the conditions below are met.
Answering system is on.
Message alert tone setting is on.
There are new messages.
1.
2.
3.
4.
5.
•
•
–
–
–
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK
SELECT
MSG ALERT TONE
On
Off
BACK
SELECT
To Next Page
Loading...
Need help?
General
