AT&T TL92273 - Appendix

89
Answering system
Message playback
When messages are playing on a cordless handset:
Press /SPEAKER to play the messages through the handset earpiece.
Press /SPEAKER again to return to playing messages through the
speakerphone.
Press CID / VOLUME/ DIR to adjust the speakerphone volume.
Press SKIP to skip to the next message.
Press REPEAT to repeat the message currently playing. Press REPEAT twice
to listen to the previous message.
Press MUTE/DELETE to delete the current message.
Press HOME/FLASH, CELL 1 or CELL 2 to pause the message playback.
The handset displays Call back? with the caller ID information. If the
dialing format used is not correct, press QUIET
#
(pound key) or 1 to show
different dialing options. Press CALL to call back the caller, or BACK to
restart the message playback.
Press 2 to pause the playback and show the caller ID information.
Press HOME/FLASH, CALL or /SPEAKER to use the home line, or
press CELL 1 or CELL 2 to use the cell line to call back the caller.
If necessary, press
#
(pound key) or 1 to show different dialing options.
Press OFF/CANCEL or BACK to restart the playback. If you do not call
back within 10 seconds, message playback restarts.
Press OFF/CANCEL to stop.
NOTES:
When the answering system has less than three minutes of recording time left, it announces,
“Less than three minutes to record.” and the handset displays Rec mem low.
When the telephone is not in use, if F and the number of messages are flashing alternately in
the message window, or the handset displays Rec mem full, the memory is full. Delete some
messages to make room for more.
•
•
•
•
•
•
•
•
•
•
•
•