AT&T TL96477 - Remote Access Code

147
Answering system
Answering system settings
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access
code is 19.
To change the remote access code:
1. Press MENU in idle mode.
2. Press CID or DIR to highlight Answering sys, then press
SELECT .
3. Press CID or DIR to highlight Ans sys setup, then press
SELECT .
4. Press CID or DIR to highlight Remote code, then press
SELECT .
5. Use the dialing keys to enter a two-digit number.
Press MUTE/DELETE on the handset or X/DELETE on the
telephone base to erase a digit.
6. Press SAVE toconrm.Youhearaconrmationtone.
ANSWERING SYS
Call screening
# of rings
Remote code
BACK SELECT
REMOTE CODE
19
BACK SAVE
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
REMOTE CODE
19
BACK SAVE