AT&T TL96477 - Telephone Base and Charger Installation; Telephone Base Installation

11
Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change to
wall-mounting, see Installation options on page 17 for details.
Telephone base installation
Raise the antenna.
Plug one end of the telephone
line cord into a telephone jack
oraDSLlter.
Plug the small end of the
telephone base power
adapter into the power
adapter jack on the back of
the telephone base.
Plug the large end of the
telephone base power adapter
into a power outlet not
controlled by a wall switch.
Route the power
adapter cord
through this slot.
Plug the other end of the
telephone line cord into the
telephone jack on the back of
the telephone base.
If you have DSL
high-speed Internet
service,aDSLlter(not
included) is required.
Route the
telephone line cord
through this slot.