29
Bluetooth
Bluetooth setup
Replace an active device
If you already have two active devices on the device list and you want to
activateadierentdevice,youmustdeactivateoneofthetwoactivedevices.
To replace an active device:
1. Press MENU on the telephone base in idle mode.
2. Press CID or DIR to highlight Bluetooth, then
press SELECT.
3. Press CID or DIR to highlight Device list, then
press SELECT.
4. Press
CID or DIR
to highlight the device you want to
activatewithoutaprexD1: or D2:, then press OPTION.
5. Press
CID or DIR
to highlight Connect, then press
SELECT. The handset displays Only BT devices in slot 1 or
2 can be ready for connection and then a list of devices
for deactivation.
6. Press
CID or DIR
to highlight the device to be
deactivated, then press NEXT. The screen displays
Cell Phone X is deactivatedandyouhearaconrmation
tone. Then, the screen displays Connecting Cell Phone Y
to the base...
(Cell Phone X and Cell Phone Y represent
the device names of your cell phones)
.
7. Depending on your cell phone settings, you may need to
pressakeyonyourcellphonetoconrmtheconnection.
When the new device is successfully activated and
connected, the handset displays Device connected.Youhearaconrmation
tone.
Note:
When connecting a Bluetooth device to the device list, all connected devices will be temporarily
disconnected until the procedure is complete. It may take up to two minutes to reconnect.
DEVICE LIST
D1:Cell Phone Y
D2:Headset X
Cell Phone X
BACK OPTION
DEACTIVATE
D1:Cell Phone X
D2:Headset X
BACK NEXT
DEVICE LIST
D1:Cell Phone X
D2:Headset X
Cell Phone Y
BACK OPTION
Connecting
Cell Phone Y
to the base...
Only BT devices
in slot 1 or 2
can be ready
for connection
To Next Page
Loading...
Need help?
General
