85
Multiple handset use
Push-to-talk (PTT)
During a one-to-group PTT call:
f To answer an incoming home call, press HOME/FLASH on any one of the
destination handsets, or press HOME on the telephone base.
f To answer an incoming cell call, press CELL 1 or CELL 2 on any one of
the destination handsets or the telephone base.
That handset or telephone base answers the outside call. The PTT call
continues for the rest of the PTT participants.
To leave the PTT call without answering the incoming call:
f Press OFF/CANCEL on the handset, or press CANCEL on the telephone
base. The telephone continues to ring.
Make an outgoing call during PTT
f During a one-to-one PTT call, press HOME/FLASH on your handset or
press HOME on the telephone base to get a dial tone. The PTT call ends
automatically.
f During a one-to-group PTT call, press HOME/FLASH on the initiating
handset, or press HOME on the telephone base. The PTT call ends
automatically and you get a dial tone.
f During a one-to-group PTT call, press HOME/FLASH on any one of the
destination handsets, or press HOME on the destination telephone base.
That handset or telephone base gets a dial tone. The PTT call continues for
the rest of the PTT participants.
End or leave a PTT call
For a one-to-one PTT call, both the initiating and destination devices can end
the PTT call. For one-to-group PTT calls, the initiating devices can end the
PTT call for the group of devices on that PTT call. If any one of the destination
devices leaves the PTT call, the call continues until all participants or the
initiator hangs up.
f Press OFF/CANCEL or END on the handset, or press CANCEL or END on the
telephone base. The screen shows Push to talk Ended.
-OR-
f Place the handset in the telephone base or charger, then the handset returns
to idle mode.
Note: After PUSH TO TALK on the handset or PT T/FLASH on the telephone base is released, the PTT call
remains open for a short time. If no one presses PUSH TO TALK on the handset or PT T/FLASH on the
telephone base within 10 seconds, the PTT call ends automatically.
To Next Page
Loading...
