25
Bluetooth
Bluetooth setup
Add a headset
Before you begin, make sure that your Bluetooth enabled headset is not
connected to any other Bluetooth device. Refer to your headset user’s manual
to learn how to search for or add new Bluetooth devices.
To pair and connect a headset:
1. Press MENU on the telephone base in idle mode.
2. Press CID or DIR to highlight Bluetooth, then press
SELECT.
3. Press SELECT to choose Add device.
4. Press CID or DIR to highlight Add headset, then press
SELECT. The screen displays Please wait... followed by
If headset is connected to cell, please disconnect it..
f If there are already four paired devices on the
device list, the fourth device on the device list will be
automatically removed, regardless of whether the new
device pairing is successful or not.
f If there is another headset already active, the screen
will show Only the BT headset in slot 2 can be ready
for connection and then Headset X is deactivated
(Headset X represents the device name of the active
Bluetooth headset).
5. Press NEXT. The screen displays Pls set headset to
discoverable mode.
6. Set your headset to discoverable mode (refer to the
user’s manual of your headset), then press NEXT. The
screen displays Searching for Bluetooth headsets....
f All devices that are connected to the telephone base
are temporarily disconnected.
7. When the screen displays the found devices, press
CID or DIR to highlight your headset, if necessary, then
press SELECT.
f Enter the PIN of your headset, if required. The PIN for
most Bluetooth devices is 0000 (refer to the user’s
manual of your headset). Press NEXT to continue.
ADD DEVICE
A d d c ellula r
Add headset
BACK SELECT
Pls set headset
to discoverable
mode
BACK NEXT
Caller ID log
Intercom
Call block
Bluetooth
BACK SELECT
BLUETOOTH
Add device
Device list
Download dir
BACK SELECT
Searching for
Bluetooth
headsets...
FOUND DEVICES
Headset Y
Headset Z
BACK SELECT
To Next Page
Loading...
