SMART ON-OFF LEVEL CONTROLLER
With the "High" mode, the high level alarm function can be
With the "Low" mode, the low level alarm function can be
With the "Off" mode, Alarm1 relay operation can be
This function "Alarm Delay" is used to avoid wrong alarms caused by water
Alarm delay can be selected between 3 to 9 seconds.
After the setting is made, the controller must be powered off and the new setting
will take effect when power is restored.
5.3.9 Reset Function
Reset function as "Reset Fonc" a safety feature offering pump functions for latching.
Pump operation will be stopped by the controller when there is an alarm.
"Reset ON" should be selected, to make the pump operated
again under operator control.
"Reset ON" should be selected, to make the pump operated
again WITHOUT operator control.
"Steam & Control Technologies"
To Next Page
Loading...
