- 12 -
Installation
1. Plug your keyboard and mouse into the console keyboard /
mouse ports located on the front side of the CS782DP. The
ports are labeled with icons with the mouse port on the top
and the keyboard port on the bottom.
Note:
The console mouse connector is a USB 2.0 port and is
compatible with any USB peripherals. You can connect a
USB hub to install multiple USB devices (this feature may
require an extra power adapter to be connected to the USB
hub and make sure that the CS782DP’s Mouse Emulation
Mode is disabled). See Hotkey Summary Table, page 16
for information.
2. Plug your monitor into the DisplayPort port, located on the
front of the CS782DP. Power on the monitor.
3. Plug your speakers into the console audio port, located on the
front of the CS782DP (Optional).
1. Make sure that the power to any device that you
connect to the installation has been turned off. You
must unplug the power cords of any computers that
have the Keyboard Power On function.
2. To prevent damage to your installation from power
surges or static electricity. It is important that all
connected devices are properly grounded.
3. Please operate the device with caution when under
high environmental temperatures, as the surface of
the device may become overheated under such
conditions. For instance, the surface temperature of
the device may reach 70 °C (158 °F) or higher
when the environmental temperature reaches close
50 °C (122 °F).
To Next Page
Loading...
