CL-1208 / CL-1216 User Manual
18
Closing the Console
To slide the console module back in, close the cover and do the following:
1. Pull the safety catches on the unit's side rails toward you and push the
module in until it stops.
2. Release the catches; pull the module slightly toward you; then push it all
the way in.
Note: The reason for the two step procedure is to minimize the chances of you
pinching your fingers when sliding the module in.
cl12816_v2.book Page 18 Thursday, March 23, 2006 2:21 PM
To Next Page
Loading...
Need help?
General
