7. Appendix
63
5. Slide the switch open and closed a couple of times to be sure that it is
properly aligned and operating smoothly. (See p.17 for opening and
closing procedures.)
6. After determining that the switch is properly lined up and operating
correctly, finish up by fully tightening down the partially tightened front
attachment screws inserted in step 3.
Dedicated Invocation Keys
Two dedicated keys are provided on the keyboard module to make it easy to
invoke Hotkey Mode and the OSD, as shown in the diagram, below
:
Note: These keys are toggles. Press once to invoke the feature, press again to
exit.
cl12816_v2.book Page 63 Thursday, March 23, 2006 2:21 PM
To Next Page
Loading...
Need help?
General
