ATEQ D6 Series User Manual

FG_D6_CCLINK_EN_02 / 2020-06-17
78 / 93
Special cycles
Special cycle table
Write the identifier number of the wanted special cycle at the address 04(h) and its instruction if
necessary.
Y040(h) → Y047(h) = identifier number of the special cycle
Y048(h) → Y04F(h) = instruction for the special cycle
Numb
Special cycle
1
ATR learning Cycle.
4
Custom Unit Learn.
5
Custom Unit Check.
9
Piezo auto zero.
13
Regulator adjust.
25
Capil. Temp. Check (*)
26
Temperature Check (*)
27
Atm Pressure Check (*)
29
Line P. Sensor Check (*)
30
Flow Check (*)
To activate a special cycle, you must send a Start command (Y001(h)) and a Start special cycle
command (Y002(h)).
(*) Appears with the Service special cycle function checked.

ATEQ D6 Series Specifications

General

Brand	ATEQ
Model	D6 Series
Category	Test Equipment
Language	English